Rover K Subframe

2012. Classic mini conversion parts using Rover K All new subframe including rear engine mount
rover k series/r65rover k series/r65
   
Manufacturer: Allspeed Engineering
£668.00
Cross

Material

 
Description Options Related Products Categories Reviews
  • The frame is all brand new and uses the standard Rover top mounts found on the bubble shaped 416 with a bespoke rear mount included with the frame. It is designed for the Rover K series and although the design offers flexibility for mounting other engines will only guarantee fitment of the 1,6 Engine and gearbox(r65) .As with all our frames this frame can use the rubber donut/coil spring replacement or coilovers, and all with standard track aand wheel base.The frame and engine/gearbox assembly will fit a standard round nose but room for an adequate size radiator and good flowing exhaust manifold will be a challenge to overcome.

    If attempting fitment into a standard round nose would also recommend a flip front as the size of the engine/gearbox assembly will be extremely tight to fit through the bonnet opening.Use of the standard injection phlenum and ecu may require bulkhead mods.

    included with this subframe :

    *Choice of front x member suitable for either standard round nose front or clubman/extended round nose

    *cambelt end and gearbox eng eng mnt bts to suit wheel type rover 216 stock mnts

    *bespoke rear eng mnt with bkts

    *subframe top washers

    *various basic fasteners for mounting engine in subframe etc.

    Additional requirements :

    Remote oil filter kit.

    The starter motor requires changing as the stock starter has the starter solenoid protuding forwards, which puts the battery live in a less than ideal position at the front of  a mini. An aftermarket starter motor with integral solenoid offers an ideal solution.

     (Please Note pictures show lower arms and tie bars in position , these are purchased separately )

    The subframe is designed for spherical jointed bottom arm and tie bars, the allspeed items are plug and play with the subframe, it may be possible to modify or adapt others to fit.

    As with every Allspeed subframe, the product is all new material manufactured by ourselves. Every subframe has gone through an extensive design and fea stress analysis progamme. Our subframes are not to be confused or compared with cut and shut 'a' series subframes or reverse engineered products. The Allspeed product is the original and designed from the outset for the application.

  • There are yet no reviews for this product.